Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3.3
Placing the antenna dish
How to mount the antenna dish on the tripod:
How to mount the antenna dish on the tripod:
3.4
Electric connection of the
Electric connection of the Travel Vision R6 ®
The system is connected with 2 coax
located outside and the power inserter
power inserter located inside. The power inserter is connected to your receiver
of the short coaxial cable (receiver is not included
ial cable (receiver is not included).
The Travel Vision R6 ® operates on 24 volt. The required 24 v
vel Vision R6 ® operates on 24 volt. The required 24 volt is supplied by the power inserter with
adapter.
By default, The Travel Vision R6 ® is suited for 1 receiver with unlimited channel reception from the chosen
The Travel Vision R6 ® is suited for 1 receiver with unlimited channel reception from the chosen
The Travel Vision R6 ® is suited for 1 receiver with unlimited channel reception from the chosen
satellite.
R6
Coax
Connection procedure:
Guide the rotation axle of the antenna dish in
socket of the tripod
Then slowly rotate the dish in either direction until the axle
Then slowly rotate the dish in either direction until
has been fixed in the tripod.
2 coaxial cables. The long coaxial cable is mounted between the
Power Inserter
Power Inserter
Coax
Firmly press the F-connector of the 15 mtr coax
connector located on the bottom of the dish unit, so that the rubber is
connector located on the bottom of the dish unit,
indented, and hand-tighten it.
of the antenna dish into the plastic
unted between the antenna unit
connected to your receiver by means
olt is supplied by the power inserter with 12V power
Receiver
Cable
coaxial cable over the
Television
page 7
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
