Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7.5
Error Voltage Low:
The voltage is too low for system to operate.
If you use the external satellite connector in your motor home or caravan: Connect the supplied 15 mtr
coaxial cable directly to the receiver and see if the system works. See also 8.1 troubleshooting
7.6
Error during software update:
Repeat the software update procedure
Check if the software has been correctly stored on the USB flash drive.
7.7
Error during software update:
Insert the USB flash drive once more.
7.8
Error messages: calibration failed, error azimuth adjustment, error elevation adjustment
ERROR DURING
CALIBRATING
Check that there are no obstructions which hinder the rotation or alignment of the dish. Remove the
control module from the antenna unit and reinsert it again.
7.9
No LNB signal:
Check if the F-connector from the Dish is connected and tightened.
Check if the LNB cable is damaged.
Check the ac power adapter for 24 V
8.0
Error E: OXBAFF
Fault in electronics. The control module requires repair, contact your dealer.
ERROR:
VOLATAGE LOW
E:FIRMWARE
NOT FOUND
E:USB DISK NOT
FOUND
ERROR AZIMUTH
ADJUSTMENT
NO LNB SIGNAL
E: OXBAFF
SEE MANUAL
ERROR ELEVATION
ADJUSTMENT
Page 16
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
