Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The control module has 4 functions:
•
Actuate
The build-in motors and electronics drive the
•
Control
Sends commands to the antenna dish, e.g. satellite choice, parking, etc...
•
Display
indicates the system's status on the display
•
Update
Replaces or updates
Replaces or updates the software
3.1
Choosing a setup location
Choosing a setup location
Several factors must be considered when deciding
•
The surface on which the ante
surface on which the antenna will be positioned should be reasonably flat.
•
The ideal location is a place where there is
The ideal location is a place where there is an unobstructed view in all directions.
•
When the view is obstructed, choose a location with
is obstructed, choose a location with an unobstructed view in the direction of the desired
satellite. This means that there should be no obstructions such as trees, trailers or RV's
satellite. This means that there shoul
3.2
Positioning the tripod
in motors and electronics drive the system
commands to the antenna dish, e.g. satellite choice, parking, etc...
commands to the antenna dish, e.g. satellite choice, parking, etc...
the system's status on the display
be considered when deciding on the location of where to set up the system:
After choosing a suitable setup location, you can unfold and position the tripod.
After choosing a
Ensure that the legs are
sure that the legs are fully extended so that the system will stand
and rigid position. The legs must be secured by means of the supplied pegs.
and rigid
Place the tripod on a surface that is as flat as possible. The surface does not have
Place the tripod on a surface
to be perfectly horizontal, but the more the unit is leveled, the quicker the syste
to be perf
will locate
locate the satellite.
Control panel buttons:
1.
Start (system starts search
2.
Park (system places itself in
Park (system places itself in the parked position)
3.
Enter (select)
4.
Arrow up
Arrow down
5.
Escape (one step back)
6.
Menu
7.
Stop
8.
USB port
9.
A USB port is located at the back of the control
A USB port is located at the back of the control
module to carry out software updates
module to carry out software updates
(see section 4.2 on how to update the software)
the location of where to set up the system:
obstructions such as trees, trailers or RV's, buildings, etc...
cation, you can unfold and position the tripod.
as flat as possible. The surface does not have
the unit is leveled, the quicker the system
searching for satellite)
how to update the software)
in the direction of the desired
system will stand in a stable
the supplied pegs.
Page
6
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
