3.6
Special remarks on searching for satellite
Special remarks on searching for satellite
1.
With a weak GPS signal, it might be possible that the GPS location cannot be determined, in which case
With a weak GPS signal, it might be possible that the GPS
the system can be used as normal. However, finding the satellite will take longer and the optimal position
the system can be used as normal. However, finding the satellite will take longer and the optimal position
the system can be used as normal. However, finding the satellite will take longer and the optimal position
of the LNB will not be provided.
of the LNB will not be provided.
2.
If you began searching for the satellite during the determination of t
If you began searching for the satellite during the determination of the GPS location, then the system
could suddenly stop searching and show the following message:
could suddenly stop searching and show the following message:
This indicates that the system has found the GPS location and that the position of the LNB/dish has to be
This indicates that the system has found the GPS location and that the position of the LNB
This indicates that the system has found the GPS location and that the position of the LNB
adjusted as shown on the display. If you do not adjust the LNB/dish position, the system may not receive
adjusted as shown on the display. If you do not adjust the LNB
a satellite signal.
Turn the LNB/dish to the correct position and press the Start button (1) and then the system will resume
searching.
3.
When the system finds a satellite with the correct characteristics, the dish will stop rotating. But if the
en the system finds a satellite with the correct characteristics, the dish will stop rotating. But if the
en the system finds a satellite with the correct characteristics, the dish will stop rotating. But if the
system concludes it has not found the selected satellite after the internal check, the following message
system concludes it has not found the selected satellite after the internal check, the following message
system concludes it has not found the selected satellite after the internal check, the following message
will be shown:
The system will automatically resume searching for the selected satellite.
The system will automatically resume searching for the selected satellite.
3.7
Removing the control module
the control module
A release pin is located on the bottom of the control module. Pr
Remark:
The control module is splash-proof so that you ca
that you remove the control module
the control module following each alignment of the system to prevent theft and possible
water damage.
OPTIMAL SIGNAL
LNB IN POSITION +3,5
to the correct position and press the Start button (1) and then the system will resume
to the correct position and press the Start button (1) and then the system will resume
ASTRA 2 28E
WRONG SATELLITE
the bottom of the control module. Press this release pin to remove
The control module is unlocked after the release pen is pressed.
Carefully remove the control module by pulling it to the right. Do this
gently to ensure that the current alignment of the dish is not altered.
proof so that you can align the system when it is raining
location cannot be determined, in which case
he GPS location, then the system
position, the system may not receive
ess this release pin to remove the control module.
unlocked after the release pen is pressed.
the control module by pulling it to the right. Do this
ensure that the current alignment of the dish is not altered.
n align the system when it is raining. We recommend
to prevent theft and possible
Page 12