Download Inhoudsopgave Inhoud Print deze pagina

Installing The Grease Filters; Odour Filter For Recirculating Air Mode; Installing The Odour Filters - CONSTRUCTA CD75132 Gebruikershandleiding En Installatie-Instructies

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Note: When cleaning the grease filter in the dish-
washer, light discolouration may occur. This discoloura-
tion has no effect on the performance of the metal
grease filters.
Requirement: The grease filters have been removed.
→ "Removing the grease filter", Page 22
Observe the information regarding the cleaning
1.
agents.
→ "Cleaning products", Page 21
Place the grease filters loosely into the dishwasher.
2.
Do not clean heavily soiled grease filters with
utensils.
Use special grease solvent for stubborn dirt. You
can obtain grease solvents from after-sales service
or the online shop.
Start the dishwasher.
3.
Select a temperature of no more than 70 °C.
Allow the grease filters to drain.
4.
7.7 Installing the grease filters
ATTENTION!
Falling grease filters may damage the hob below.
Grip below the grease filter with one hand.
Carefully insert the grease filters
1.
The locks engage
2.
Ensure that the locks engage.
3.
7.8 Odour filter for recirculating air mode
Odour filters bind odorous substances in air recircula-
tion mode. Regularly replaced odour filters guarantee a
high level of odour removal.
With normal use (approx. one hour a day), the odour fil-
ter must be replaced every 6  months. The odour filter
cannot be cleaned or regenerated.
You can obtain odour filters from the after-sales service
or the online shop. Only use original odour filters.
→ "Accessories", Page 25
7.9 Installing the odour filters
Requirement: The grease filters have been removed.
→ "Removing the grease filter", Page 22
​ ⁠ .
​ ⁠ .
Insert the screw through the wing nut and the
1.
sleeve, and screw it in in the centre of the intermedi-
ate floor.
The screw, wing nut and sleeve are included with
the odour filter.
If the appliance has a spacer rail, remove this.
2.
Use a screwdriver to push the two tabs on the inter-
3.
mediate floor inwards.
Use the enclosed sealing strips to mask the odour
4.
filter.
Insert the odour filter at the rear
5.
Cleaning and servicing en
​ ⁠ and fold it up
​ ⁠ .
23

Advertenties

Inhoudsopgave
loading

Inhoudsopgave