Download Inhoudsopgave Inhoud Print deze pagina

Atag HI8471SVC Gebruiksaanwijzing pagina 58

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

FAULTS
Symptom
The pans make a noise while
cooking.
You have switched a cooking
zone on but the display keeps
flashing.
A cooking zone suddenly
stops working and you hear
a signal.
The hob is not working
and nothing appears in the
display.
A fuse blows as soon as the
hob is switched on.
'BR' appears in the display
and the operation does not
react.
After you have switched on
a cooking zone, another
cooking zone that was being
used with an automatic
cooking program is
simultaneously stopped.
Fault code E1 and E3 / the
red child lock indication and
the pause indication are
illuminated.
Fault code E2 / the red child
lock indication and the pause
indication are illuminated.
Fault code E4 and E5.
Fault code E6
EN 28
Possible cause
This is caused by the energy
flowing from the hob to the
saucepan.
The pan you are using is not
suitable for induction cooking
or has a diameter of less than
12 cm.
The preset time has ended.
There is no power supply
due to a defective cable or a
faulty connection.
The hob has been wrongly
connected.
The bridge function is
switched on.
This is a safety function.
The maximum power of
the combination of cooking
settings was exceeded.
Software error
The control panel is dirty or
has water on it.
The wifi module is defect.
The appliance is connected
wrong to the power supply.
Solution
This is normal for certain
pans at a high cooking
setting. This is not harmful for
the pans or hob.
Use a suitable pan (see pages
10 and 11).
Switch the signal off by
pressing on the - or + key of
the timer.
Check the fuses or the
electric switch (if there is no
plug).
Check the electrical
connections.
Switch the bridge function off
(see page 14).
Reset the automatic cooking
program and use a lower
setting for the other cooking
zone.
Disconnect the appliance
for a short moment from
the power supply. Contact
the service department if
the error code does not
disappear.
Clean the control panel.
Contact the service
department.
Contact the installer.

Advertenties

Hoofdstukken

Inhoudsopgave
loading

Inhoudsopgave