Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Troubleshooting
Adjusting the LCD screen (CALIBRATION)
The buttons on the touch panel may not work correctly. If this happens, follow the
procedure below.
(1) Set the POWER switch to (CHG) OFF.
(2) Eject the tape from your camcorder, then disconnect any connecting cable from
your camcorder.
(3) Close the LCD panel with the LCD screen facing out.
(4) Set the POWER switch to VCR while pressing DISPLAY/TOUCH PANEL,
then keep pressing DISPLAY/TOUCH PANEL for about five seconds.
(5) Follow the procedure below with your finger or the supplied stylus.
1 Touch
2 Touch
3 Touch
CALIBRATE
If you do not press the right spot,
left corner.
Note
You can only carry out this operation with the LCD screen in the step 3 position.
For details on adjusting the LCD screen (CALIBRATION), refer to the Operating
Instructions with your comcorder.
at the upper left corner.
at the lower right corner.
in the middle of the LCD screen.
CALIBRATE
DISPLAY/TOUCH
PANEL
CALIBRATE
always returns to the position at the upper
99
-GB
Advertenties
Hoofdstukken
Inhoudsopgave
