Advertenties
Beschikbare talen
Beschikbare talen
Installation/Connection
Part list for installation
(A) Faceplate (×1)
(B) Trim plate (×1)
(C) Mounting sleeve (×1)
(D) Wiring harness (×1)
(E) Extraction key (×2)
(for KD-T922BT/
(for KD-X38MDBT)
KD-DB622BT)
Basic procedure
1 Remove the key from the ignition switch, then disconnect
the
terminal of the car battery.
2 Connect the wires properly.
See "Wiring connection" on page 42, 43.
3 Install the unit to your car.
See "Installing the unit (in-dash mounting)" on page 40, 41.
4 Connect the
terminal of the car battery.
5 Press B SRC to turn on the power.
6 Detach the faceplate and reset the unit within 5 seconds.
(Page 4, 5, 6)
40
ENGLISH
Installing the unit (in-dash mounting)
Orientate the trim
plate as illustrated
Installing the unit (without mounting sleeve)
(for KD-T922BT/KD-DB622BT)
1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with screws
(commercially available).
Self-tapping screw type
Use only the specified screws. Using wrong screws might damage
the unit.
(for KD-T922BT/KD-DB622BT)
Hook on the top side
before fitting.
Bend the appropriate tabs to hold the
sleeve firmly in place.
Removing the unit
(for KD-T922BT/KD-DB622BT)
Do the required wiring.
(Page 42, 43)
Dashboard of
your car
Advertenties
