Advertenties
en
|
Operation
Marking added-signal channels (X-am 5800 only):
Feature
Toxic Twins
CO H
compensation
2
H
added signal
2
1) Example illustration with methane (CH4) for IR sensors.
3.2
Intended use
Dräger X-am 2800/X-am 5800 is a portable gas detector for
continuous monitoring of the concentration of several gases in
the ambient air within the working area and in explosion-
hazard areas.
The gas detector is suitable for both indoor and outdoor
applications for which an IP 68 degree of protection and
certified explosion protection (see name plate) are sufficient.
The gas detector is not suitable for use under jets of water.
3.3
Approvals
A copy of the name plate, the declaration of conformity, and
the sensor data relevant for measurement purposes are
provided in the enclosed supplementary documentation (part
no. 9300308) or at www.draeger.com/ifu.
The name plate on the gas detector must not be damaged
or concealed. If the name plate is damaged, it must be
replaced by Dräger Service.
FCC:
The radio license information can be found in the information
on the device. For further information see: "Opening device
information", page 26.
3.4
GPL (General Public License)
Depending on their configuration, Dräger products which use
software use Open Source software. This is regularly subject
to special licensing conditions which take precedence in their
scope. Several Open Source software licensing conditions
may apply in a single Dräger product, which then apply
respectively to the associated software components. Further
information on the Open Source software used in this
products is available on the following Internet page: www.
draeger.com/opensource.
4
Operation
4.1
Symbol explanations
Symbol
Explanation
Bump test
Fresh air calibration
Single-gas calibration
22
Shown in display
HCN+
CO+
1)
ch
+
4
Symbol
Explanation
Mixed gas calibration
Measurement range exceeded
Readings below the measurement range
Peak value
Protection alarm (only CatEx sensor)
Channel error
Compliance with bump test interval.
Warning message
The gas detector can be operated nor-
mally. If the warning message is still dis-
played after operation, the gas detector
requires maintenance.
Fault message
The gas detector or measuring channel is
not ready to measure and requires mainte-
nance.
Information message
STEL alarm message
TWA alarm message
Gas detector in maintenance mode
Bluetooth
(flashing) Bluetooth
Bluetooth
(dashes flashing) Gas detector ready for
coupling
Battery state of charge
Display pump information
4.2
Signalling concept
4.2.1 Acoustic life signal
A periodic acoustic signal indicates that the device is
operational. The acoustic life signal can be deactivated using
the Dräger CC-Vision PC software.
4.2.2 Visual life signal and D-Light
The visual life signal can be extended by the D-Light feature
with activated interval check. An activated D-Light feature
allows the user to also check and indicate compliance with
certain settings.
The D-Light feature can be activated using the Dräger CC-
Vision PC software.
Instructions for use
|
X-am
®
activated
®
connection lost
®
connection established
®
®
2600 / X-am
2800 / X-am
®
5800
Advertenties
