Advertenties
14 NOISE
Noise values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A)
aw (Vibration)
15 STORING A CHAIN SAW
Caution: never store a chain saw for longer than 30 days without performing the following
procedures. Storing a chain saw for longer than 30 days requires storage maintenance.
Unless the storage instructions are followed, fuel remaining in the carburetor will evaporate,
leaving gum-like deposits. This could lead to difficult starting and result in costly repairs.
▪
Remove the fuel tank cap slowly to release any pressure in tank. Carefully drain the fuel
tank.
▪
Start the engine and let it run until the unit stops to remove fuel from carburetor.
▪
Allow the engine to cool (approx. 5 minutes).
▪
Using a spark plug wrench, remove the spark plug.
▪
Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Pull starter rope slowly
several times to coat internal components. Replace spark plug. (Fig.24)
Note: store the unit in a dry place and away from possible sources of
ignition such as a furnace, gas hot water heater, gas dryer, etc.
Removing a unit from storage
▪
Remove spark plug.
▪
Pull starter rope briskly to clear excess oil from combustion chamber.
▪
Clean and gap spark plug or install a new spark plug with proper gap.
▪
Prepare unit for operation.
▪
Fill fuel tank with proper fuel / oil mixture. See fuel and lubrication section
Copyright © 2022 VARO
POWEG2030
104dB(A)
117dB(A)
9.5m/s²
P a g e
| 19
EN
K = 1.5 m/s²
www.varo.com
Advertenties
