Inhoudsopgave
Advertenties
■
Remain alert at all times! Always pay attention
to what you are doing and act with common
sense. Do not use the appliance if you are dis-
tracted or feeling unwell.
WARNING!
Always wear safety goggles.
WARNING!
Always wear a dust mask!
Before use
Charging the battery pack (see fig. A)
CAUTION!
►
Always pull out the plug before you remove
the battery pack
battery pack to the charger.
■
Never charge the battery pack
ambient temperature is below 10°C or above
40°C.
♦
Connect the battery pack
battery charger
♦
Insert the power plug into the socket. The control
LED
lights up red.
♦
The green LED
indicates that the charging
process is complete and the battery pack
ready.
CAUTION!
♦
If the red control LED
that the battery pack
cannot be charged.
♦
If the red and green control LEDs
flash, this means that the battery pack
defective.
♦
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
PWSA 20-Li A1
from or connect the
when the
to the high-speed
(see fig. A).
flashes, this means
has overheated and
both
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦
Allow the battery pack
handle.
Removing the battery pack:
♦
Press the release button
battery pack
Checking the battery charge level
♦
Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
♦
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Fitting the blade guard with quick
release
WARNING! RISK OF INJURY
►
Always switch the appliance off and remove
the battery before carrying out any work on
the appliance.
is
RISK OF INJURY
►
Always use the angle grinder with the blade
guard
securely. Set this so that the highest possible
degree of safety is achieved, i.e. the smallest
possible part of the grinding disc is open to
the operator. The blade guard
to protect the operator from fragments and
is
accidental contact with the grinding tool.
to click into the
and remove the
.
as follows:
. The blade guard should be fitted
GB │ IE │
to
is designed
29
■
Advertenties
Hoofdstukken
Inhoudsopgave
