Advertenties
6.5
Setting the units to be used
1. When switching the laser receiver on, press and hold the
▶ The menu is then shown in the display.
2. Use the
button to toggle between metric or imperial units of measurement.
3. Switch off the laser receiver by pressing the
▶ The settings will be saved.
6.6
Changing the units used by the laser receiver
1. When switching the laser receiver on, press and hold the
▶ The menu is then shown in the display.
2. Press the
button repeatedly.
▶ The desired accuracy (mm/cm/off) is shown alternately in the digital display.
3. Switch off the laser receiver by pressing the
▶ The settings will be saved.
6.7
Adjusting the volume level on the laser receiver
▶ Press the
button repeatedly.
▶ The digital display cycles through the volume levels (low/normal/high/off).
"Normal" is the default volume when the laser receiver is switched on.
6.8
Adjusting the signal tone on the laser receiver
1. When switching the laser receiver on, press and hold the
▶ The menu is then shown in the display.
2. Use the
button to assign the rapid signal tone to the upper or lower detection area.
3. Switch the laser receiver off by pressing the
▶ The settings will be saved.
6.9
PRA 30 Menu options
The laser receiver is switched off.
Press the
button for 2 seconds.
Menu option fig.1 is displayed.
To switch between the menu options, press the
To save the settings, switch the laser receiver off.
34
English
button for two seconds.
button.
button for two seconds.
button.
button for two seconds.
button.
or
direction buttons.
2134492
*2134492*
Advertenties
