Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
It is essential that the voltage on the machine's rating plate corresponds to the power
source, otherwise the machine could get hot, smoke could develop, start a fire and cause
damage!
The integrated overload protection automatically stops the machine in the event of an
overload or power fluctuations! Switching back on is not possible until one minute has
elapsed!
Use the extension cable H07 RN 3 x 1.5 mm2! The cable should not be longer than 30m!
4.4
The thread cutting oil
For tapping, use ROTHENBERGER high-performance thread-tapping oil art. no. 65010.
This oil is not suitable for tapping drinking water pipes!
Alternatively, you can use ROTHENBERGER high-performance thread-tapping fluid, art. no.
65015. This fluid is suitable for tapping all pipelines including drinking water pipelines.
Keep thread-tapping oils out of the reach of children!
Do not thin thread-tapping oil or mix it with other oils! If the thread-tapping oil becomes
mixed with water, it turns milky-white, its quality is reduced and the tapped thread displays
lower quality. It is then recommended to change the oil!
Avoid direct sunlight and store the oil in a dark place!
Close the oil container tight after use in order to prevent the ingress of dirt and water!
ATTENTION PERSONS WITH ALLERGIES!
Thread-tapping oil that lands on the skin can cause skin irritation, inflammation and
allergic reactions! When handling oil, wear protective clothing and cover exposed skin
areas. If your skin comes into contact with oil, wash it immediately with tap water and
soap. If thread-tapping oil burns onto hot workpiece or tool surfaces, this can produce
toxic vapours or gases (e.g. chlorine gas when red oil burns). If you have accidentally
inhaled this oil mist or oil vapours, go out into the fresh air immediately and consult a
doctor without delay!
4.5
Checking the thread cutting oil
When cleaning, servicing, inspecting or repairing the machine, it is essential to switch it
off and pull out the mains plug (de-energised operation)!
Turn the rotary handle clockwise in order to move the tool
carriage to the clamping chuck.
On the right side of the machine, fill up with the thread
tapping oil to the level of the sieve mesh.
Ensure that the machine is still switched off and insert the
mains plug back into the socket.
Switch on the machine and ensure that the thread-tapping
oil runs out of the thread-tapping head to the cutting jaws. If
the right amount of oil is not supplied, regulate it with the oil
adjustment screw.
4.6
Setting the supplied thread cutting oil quantity
When cleaning, servicing, inspecting or repairing the machine, it is essential to switch it
off and pull out the mains plug (de-energised operation)!
ENGLISH
23
Advertenties
Hoofdstukken
Inhoudsopgave
