Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3
Installation
The CANVXCJP interface can be mounted out of sight in a not perma-
nently accessible, ventilated, location.
3 .1
Connecting the CAN bus cables
Refer to the CAN bus principle diagram on page 51 for connecting
the CANVXCJP.
The CAN bus power supply must always be
n
ote
connected to 12 Volt
Refer to the appropriate bow or stern thruster installation manual
for detailed CAN-bus diagrams and configuration of a bow or
stern thruster.
4
Checking/test running and configuring the control panels
4 .1
General
Check whether the system is connected correctly. Then switch on the
CAN-bus supply voltage and the supply voltage of the bow and/or
stern thruster.
4 .2
Switch on control interface
Switch on the battery main switch. The system is now 'standby' .
• Press the 'ON/OFF' button
on the joystick.
You will hear a repeating signal, di-di-di ( . . . ). Within 6 seconds, the
'ON/OFF' button must be pressed for the second time. The buzzer
confirms with a signal, dahdidah (- . -), that the control interface is
ready for use.
4 .3
Switching control interface
To transfer control in a system with multiple control interfaces, follow
the instructions described in section 4.2.
4 .4
Switch off control interface
Press and hold the 'ON/OFF' button until you hear the signal, di-di-di-
dah-dah ( . . . - - ). The control interface is switched off.
• When disembarking, switch off the battery main switch.
Installation manual BOWPRO control interface CANVXCJP
3 .2
Connecting the joystick
The supplied wiring harness is suitable for connecting one CANVX-
CJP control interface and one VETUS joystick. If a multi-joystick sys-
tem is used, a separate CANVXCJP control interface must be installed
for each joystick.
Connect the large connector of the wiring harness to the CANVXCJP
and the small connector to the VETUS joystick.
4 .5
Checking thrust direction
The direction of movement of the boat must match the di-
rection of movement of the joystick . You must check this for
EVERY CANXVCJP control interface! Do this carefully and in a
safe location .
ON/OFF
• If the movement of the boat is opposite to the direction in which
the joystick is moved, this must be corrected as shown in 4.7.
4 .6
Restoring factory settings
Switch off all control interfaces (see 4.4). On the control interface to
be restored, perform the following operations:
1. Press and hold the 'ON/OFF' button for 30 seconds.
2. After 30 seconds, the signal sounds, dah-di-di-di-dah ( - . . . - ).
Now release the 'ON/OFF' button.
3. Press the 'ON/OFF' button once. The signal, dah ( - ) sounds. The
factory settings of this control interface are restored.
n
ote
Refer to the installation diagram on page 51
W
arninG
+
ENGLISH
11
021004.11
Advertenties
Inhoudsopgave
