Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Optima Auto Link / English
(4) Plug the power cord into electrical outlet.
NOTE: Make sure the pump unit is suitable for the local power voltage.
NOTE: The plug is also served to stop the device.
NOTE: Pump might still be in operation after the power cord disconnection
if optional battery is built-in.
(5) Turn the power switch to ON position.
CAUTION: The pump can only be applied to the mattress recommended by
the manufacturer. Do not use it for any other purpose. (Applied part: air
mattress) Do not position the equipment so that it is difficult to operate the
disconnecting device.
CAUTION: Allow the mattress to inflate before positioning the patient on
the mattress.
(6) The cable management tape is provided along the side of the mattress to manage power
cord. Please make sure the wire has no signs of damage. After installation, extra length of
the power cord, if any, should be neatly managed to prevent stumble accident and should
be clear of moving bed mechanisms or other possible entrapment areas.
NOTE: The EQUIPMENT should be firmly placed at position where users
can easily access to.
3.2. Position Sensor- installation & removal
The position sensor is the key to automatic seat inflation. It
allows the mattress to inflate automatically with the head
section raised to prevent bottoming out.
To activate this function, connect the sensor cable to the unit.
The electrical connector is supplied with a keying block to
ensure correct insertion. Leave the flat side facing up. To attach,
insert the cord as shown; or pull out to release.
Warning: Do not immerse the unit in water.
9
Advertenties
Inhoudsopgave
