Advertenties
Beschikbare talen
Beschikbare talen
The vacuum time is counted down to 0 and the indicator lamp Vacuum & Seal and Seal
are flashing for a few seconds then they turn off. Open the lid.
For best marinate results repeat this process 2-3 times. After each operation stir the food
with a spoon. Open the lid and take out the canister.
17.9 Vacuum packing in a container outside the chamber
Wipe the vacuum container and its lid to make sure they are clean and dry. Fill the vacuum
goods into the canister. Be careful not to fill in too much vacuum goods. Close the
container with its lid. Open the device's lid. Attach one end of the vacuum hose to the
device's connector and the other end to the connector on the container lid or use a
corresponding adapter on the container lid. Set the vacuuming and sealing time as
desired. Make sure that the vacuuming time is not too long as the container could burst if
the pressure becomes too high. Press „Vacuum & Seal". To ensure there is no air leaking
between the cover and the canister, use your hand to push down the cover at the
beginning of the vacuum operation. You can stop the process at any time by pressing the
"Cancel" button. Remove the vacuum hose from the cover of container first then from the
connector at device.
17.10 Opening of a sealed bag
Cut the bag straight across with scissors just inside the seal.
17.11 Storage
Store the unit in its upright position, out of the reach of children.
► Unplug the device after using. So you reduce the unnecessary energy consumption and
ensure your safety.
► Always unplug the appliance from its outlet immediately after using and before cleaning.
18 Cleaning and Maintenance
This chapter provides important information on properly cleaning and maintaining your
vacuum sealer.
18.1 Safety information
ATTENTION
Please observe the following safety notices, before cleaning the unit to avoid damage to
the unit or personal injury:
► To ensure optimum performance, the unit must be cleaned regularly. Failure to clean
the unit regularly can lead to potential malfunctions, as well as safety and health risks.
► Unplug the device before to cleaning. The sealing strip remains hot after use. Wait a
few minutes until the strip has cooled before cleaning.
► Clean the unit after every use as soon as it has cooled. Leaving the unit uncleaned for
long periods can make it very difficult to remove leftover food and grime and may even
damage the unit.
PLEASE NOTE
46
Advertenties
