Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
charging�
z Risk of leakage from
batteries/rechargeable
batteries
Avoid exposing batteries/rechargeable
„
batteries to extreme conditions and
temperatures, e�g� on radiators/in direct
sunlight�
Avoid contact with skin, eyes and mucous
„
membranes! In the event of skin contact
with battery acid, rinse the affected area
immediately with plenty of clean water and
seek medical advice immediately!
WEAR PROTECTIVE GLOVES!
„
Leaking or damaged batteries/
rechargeable batteries can cause
chemical burns if they come into contact
with the skin� Therefore, wear suitable
protective gloves in such cases�
In the event that a battery leaks, remove it
„
from the product immediately to avoid
damage�
z Assembly and installation
Please note: dispose of all packaging
material�
Suitable for hand-held use only� Alternatively,
the cordless work lamp can be attached to a
metal surface by means of the magnet
Make sure you protect the surface if it is of a
type that marks easily� Make sure that the
surface is flat and level to ensure the light is
firmly attached. Alternatively, the cordless
work lamp can also be attached by means
of the hook
�
8
z Charging the battery
If the lamp is on, switch it off by pressing
„
the ON/OFF button
Place the charging station
„
level surface, making sure to protect the
�
7
�
4
on a flat,
9
surface if it is of a type that marks easily�
Place the cordless work lamp
„
charging station supplied
the USB charging cable
USB port
on the charging station
11
and connect the other end of the cable to a
standard SELV USB interface�
The battery will then start charging� The
„
battery charge level of the cordless work
lamp
is indicated by the blue flashing
1
light of the three-level charge status
indicator
�
5
Level one
= approx� 35 %,
Level two
= approx� 67 %,
Level three
= 100 %
The charging station
„
LED
that indicates when it is ready for
10
use� The standby LED
whenever the charging station
connected to a power source�
The cordless work lamp can also be
„
charged without the charging station� To do
so, connect the USB charging cable
the micro-USB port
USB interface�
z Switching the cordless
work lamp ON/OFF
Unfold the cordless work lamp�
„
The ON/OFF button
„
cordless work lamp on/off and also
controls its brightness� The battery charge
level is indicated by the charge status
indicator
� Pressing the ON/OFF button
5
once sets the COB LED to 100%
4
brightness� Pressing the ON/OFF button
again reduces the COB LED brightness
4
to 50%� Pressing the ON/OFF button
third time switches the COB LED off and the
LED (front light)
2
(front light) off, press the ON/OFF button
once again�
4
in the
1
� Now connect
9
to the micro-
12
9
has a red standby
9
is permanently on
10
is
9
12
and a standard SELV
6
switches the
4
4
on� To switch the LED
GB
to
a
27
Advertenties
Inhoudsopgave
