Download Inhoudsopgave Inhoud Print deze pagina

Before Use; Charging The Product; Checking The Battery Capacity; Operation - Parkside PBSL 5000 B1 Bedienings- En Veiligheidsinstructies

Led-schijnwerper met powerbank-functie
Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

This product has a built-in rechargeable
 
battery which cannot be replaced by the
user . The removal or replacement of the
rechargeable battery may only be carried out
by the manufacturer or his customer service
or by a similarly qualified person in order
to avoid hazards . When disposing of the
product, it should be noted that this product
contains a rechargeable battery .
˜ Before use
˜ Charging the product
NOTES:
Remove all packaging materials from the
o
product .
In order to use the product without a
o
USB cable
, you need to recharge the
10 ]
[
rechargeable battery before use . The
charging process takes about 6 .5 hours . The
rechargeable battery is firmly integrated into
the base of the product .
Fully charge the rechargeable battery prior
o
to first use .
Charge the battery if it becomes empty
o
(only 1 LED of the charging indicator
flashing) .
1 . Open the protective cap
2 . Connect the USB plug of the USB cable to the
USB input socket
[
8 ]
NOTES:
The battery charging status is shown by the
o
charging indicator
Charging
indicator
status
6 ]
[
1 LED flashes
1 LED lights up, 1 LED
flashes
2 LEDs light up, 1 LED
flashes
3 LEDs light up
The charging time is approximately 6 .5 hours
o
when the battery was drained .
is
[
6 ]
.
7 ]
[
on the product .
:
6 ]
[
Battery
charging status
0‒33 %
34‒65 %
66‒99 %
100 %
The product has an overcharging protection
o
system . Nevertheless, you should disconnect
the product from the mains once the charging
process is complete .
The product is not working at temperatures
o
below +5 °C and above +45 °C due to its
battery protection .
1 . Disconnect the USB cable
product to prevent the batteries discharging
themselves .
2 . Close the protective cap
to use the product again . Otherwise water
could enter to the product when it is used
outdoors .
˜ Checking the battery capacity
When product is not charged: Press the
o
ON/OFF switch
2 ]
[
capacity . The red charging indicator
shows the capacity* of the battery inside the
product .
1 LED lights up
=
2 LEDs light up
=
3 LEDs light up
=
* This is the approximate percentage of battery
capacity but not actual measurement .
˜ Mounting the product
m
CAUTION! A single adjustable foot/hand
grip
is not sufficient for attaching the
[
4 ]
product to magnetisable surfaces (Fig . E) .
Each of the adjustable 2 foot/hand grips
o
is equipped with 4 magnets
magnets, the product can be attached to
magnetisable surfaces .
˜ Operation
m
RISK OF ACCIDENTS! Preferably do
not use the product whilst driving a vehicle .
When using the product in a vehicle, be
sure this does not endanger the driver or
the passengers . Always store and secure
the product so that even full braking does
not pose a risk of injury from the product or
product damage .
from the
10 ]
[
before you start
7 ]
[
to check the battery
6 ]
[
33 %*
66 %*
100 %*
4 ]
[
. With these
5 ]
[
GB/IE/NI
9

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

499633 2204Hg08322

Inhoudsopgave