Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Turn the adjustable foot/hand grip
o
and fix the product at desired position . The
adjustable foot/hand grip can also be turned
up and used as a hand grip (Fig . C) .
The product can be fixed by attaching it to a
o
flat ferromagnetic surface with the magnet
of the adjustable foot/hand grip .
The product can be hung up . Press the grip
o
lock
to release the adjustable foot/hand
[
11 ]
grip (Fig . D) . Push the adjustable foot/hand
grip back in after hanging the product at a
desired position .
m
CAUTION! Please note the position of your
hands whilst turning the adjustable foot/hand
grip to prevent pinching your fingers .
NOTES:
The product may be used as a light or as a
o
charger .
The energy stored in the rechargeable
o
batteries power both the LED light and the
charging station . Using the product as a
charger therefore reduces the operating time
and brightness in lighting mode .
˜ Using as a LED light
Fully charge the product as described in the
o
section "Charging the product" .
The product can be operated in 3 different
o
modes . Select these by repeatedly pressing
the ON/OFF switch
ON/OFF switch
Press 1x:
Press 2x:
Press 3x:
Press 4x:
˜ Using as a power bank
ATTENTION! Charging a device which requires
a higher charging current may cause a defect in
both devices .
The charging current the device requires
may not exceed 2 A . Carefully read the
instructions for use of the device you wish to
charge .
10 GB/IE/NI
4 ]
[
5 ]
[
.
[
2 ]
Mode
2 white lights light up .
1 white light lights up .
1 white light lights up .
Switch off the light .
The battery of the device you wish to charge
must have a significantly smaller capacity
than the total capacities of the rechargeable
batteries inside the product (5000 mAh) .
Otherwise charging may not complete .
When used with the USB cable
o
product may be used to charge small
electronics devices with USB socket (Type C)
for charging (e .g . mobile phones or digital
cameras) .
1 . Open the protective cap
2 . Insert the USB plug of the USB cable
the USB output socket
3 . Insert the USB plug of the USB cable into the
small electronic devices you wish to charge .
The red charging indicator
indicating the battery capacity .
4 . Remove the USB cable as soon as charging
is complete .
5 . Close the protective cap .
˜ Maintenance and cleaning
Never immerse the product in water or other
liquids .
Never use caustic cleaners .
The product requires no maintenance . The
LEDs cannot be replaced .
Before cleaning:
o
–
Switch off the product .
–
Disconnect the USB cable
socket .
–
Close the protective cap
input socket
and USB output socket
[
8 ]
Regularly clean the product with a dry, lint-
o
free cloth . Use a slightly moist cloth to remove
any stubborn dirt .
˜ Disposal
The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities .
, the
[
10 ]
.
7 ]
[
into
[
10 ]
.
9 ]
[
lights up,
[
6 ]
from the USB
[
10 ]
on the USB
[
7 ]
.
9 ]
[
Advertenties
Hoofdstukken
Inhoudsopgave
