Electronic Programmer - Amica SHC Series Gebruikershandleiding
Verberg thumbnails
Zie ook voor SHC Series:
- Gebruikershandleiding (112 pagina's) ,
- Gebruikershandleiding (64 pagina's) ,
- Gebruikershandleiding (76 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
ELECTRONIC PROGRAMMER*
ELECTRONIC PROGRAMMER (optio-
A - display field
B - work function symbols
- work time
- turn-off time
- timer
- current time
- signal lamp
1 - programmer work function selection
button
2 - button „-"
3 - button „+"
CURRENT TIME SET-UP
After plugging in or reconnecting to a power
source after current decay, the display shows
12.00, and the lamp at
•
set up the current time using buttons
2 and 3.
About 5 sec. after the time set-up has been
finished, new data will be memorized and the
lamp at
will go out.
The time correction can be done later, press-
ing button 1 until the lamp at
Then you can correct the current time.
Notice!
If the current time is not set up, it is impossible
for the oven to work.
*optional
flashes,
starts to flash.
11
A
B
2
TIMER
You can activate the timer at any time, regard-
less the activity state of other programmer
functions. The measured time ranges from 1
minute to 23 hours 59 minutes. With the aim
of setting up the timer:
•
press button 1 until the lamp at
starts to flash, and the display
shows "0.00",
•
set up the timer using buttons 3 and
2,
The set-up time is presented on
the display, and the lamp at
turned on.
After the set-up time has elapsed, a sound
signal turns on and the lamp at
flash again,
•
press buttons 1, 2 or 3 to turn the
signal off; the lamp will go out, and
the display will indicate the current
time.
Notice!
If the sound signal is not turned off manu-
ally, it will turn off automatically after about
2 minutes.
B
1
3
starts to
is
Advertenties
Hoofdstukken
Inhoudsopgave
