Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
50 Progress
Problem and alarm code
Rattling/knocking sounds from inside
the appliance.
The appliance trips the circuit-beaker.
Refer to "Before first use",
"Daily use", or "Hints and
tips" for other possible causes.
Once you have checked the appliance,
press Start. If the problem occurs again,
contact an Authorised Service Centre.
The washing and drying results are not satisfactory
Problem
Poor washing results.
Poor drying results.
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry water
drops on glasses and dishes.
The dishes are wet.
The interior of the appliance is
wet.
Possible cause and solution
• The tableware is not properly arranged in the
baskets. Refer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultane-
ously all the appliances in use. Check the socket
amperage and the capacity of the meter or turn
off one of the appliances in use.
• Internal electrical fault of the appliance. Contact
an Authorised Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
Possible cause and solution
• Refer to "Daily use", "Hints and tips" and basket load-
ing leaflet.
• Use more intensive washing programs.
• Tableware has been left for too long inside a closed appli-
ance.
• There is no rinse aid or the dosage of rinse aid is not
enough. Set the rinse aid dispenser to a higher level.
• Plastic items may need to be towel dried.
• The release quantity of rinse aid is too much. Adjust the
rinse aid selector to a lower position.
• The quantity of detergent is too much.
• The released quantity of rinse aid is not sufficient. Adjust
the rinse aid selector to a higher position.
• The quality of the rinse aid can be the cause.
• The programme does not have a drying phase or has a
drying phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• This is not a defect of the appliance. it is caused by the
humidity in the air that condenses on the walls.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
