Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Fill the rotating basket and insert it into the device:
1. Open the ap of the rotating basket (see Illustration D).
2. Fill the rotating basket no more than ¾ full with food. It should not be too full to ensure
that the food is cooked evenly.
3. Close the ap and ensure that it is shut correctly so that it does not open during use.
4. First insert the left-hand side with the L marking of the rotating basket into the cooking
space (16) (see Illustration C1). To do this, plug the left end (with just one notch) of
the shaft as far as it will go into the round holder on the left-hand side of the cooking
space. Then hang the other end (with two notches) of the shaft into the support on
the right-hand side of the cooking space.
5. Check that it ts securely. The rotating basket must not be able to rotate about its own
axis when the device is switched off. If this is not the case, plug the left-hand end of
the shaft deeper into the holder.
After use, remove the hot rotating basket from the cooking space using the removal tool
(see the "Removal Tool" section). Always use oven gloves to open and empty the rotating
basket.
Removal Tool
The hot rotating basket, rotating spit or the hot rack containing skewers is taken out of
the cooking space using the removal tool (5).
1. Place the ends of the removal tool under the shaft (see Illustration E).
2. First lift up the right-hand side of the shaft and move it forwards a little until the left
end of the shaft is released from the holder.
3. Carefully lift the rotating basket, rotating spit or the rack out of the cooking space (16)
and place down on a heat-resistant surface.
Before Initial Use
1. Check the items supplied for completeness (see the "Items Supplied" chapter) and
possible transport damage. If you nd any damage, do not use the device (!), but
rather contact the customer service department.
2. Remove any possible lms, stickers or transport protection from the device. Never
remove the rating plate and any possible warnings!
3. The device should be used for the rst time without any food in it as it may produce
some smoke or odours due to coating residues. Allow the device to heat up on the
highest temperature setting for approx. 15 minutes without any food in it (see the
"Basic Use of the Device" chapter).
4. Thoroughly rinse all accessories. Follow the instructions in the "Cleaning" chapter to
do this.
02095_ 02363_ 04180_ 04184_ 04189_de-en-fr-nl_A5_V2.indb 32
32
12.10.2018 14:43:34
Advertenties
Hoofdstukken
Inhoudsopgave
