Download Inhoudsopgave Inhoud Print deze pagina

General Safety Instructions; Before Installation - Parkside PASG 30 A1 Bedienings- En Veiligheidsinstructies

Led-werklamp
Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

General safety instructions

BEFORE USING THE PRODUCT, PLEASE
FAMILIARISE YOURSELF WITH ALL OF THE
SAFETY INFORMATION AND INSTRUCTIONS
FOR USE! WHEN PASSING THIS PRODUCT ON
TO OTHERS, PLEASE ALSO INCLUDE ALL THE
DOCUMENTS!
m
WARNING! RISK OF DEATH
AND ACCIDENTS FOR
TODDLERS AND CHILDREN!
Never leave children unattended with the
packaging material . The packaging material
represents a danger of suffocation . Children
frequently underestimate the dangers . Keep the
product out of the reach of children at all times .
This product can be used by children from
 
8 years and above, and persons with reduced
physical, sensory or mental capacities, or
lacking experience and/or knowledge, if they
are supervised or have been given instructions
concerning use of the product in a safe way
and understand the hazards involved . Children
shall not play with the product . Cleaning
and user maintenance shall not be made by
children without supervision .
m
DANGER! Risk of suffocation! Children
could swallow and choke on small included
parts (e .g . screws) . Keep children away from
the work area during assembly .
This product does not contain any parts that
 
can be serviced by the user . The LEDs and the
built-in control gear cannot be replaced by the
user .
8
GB/IE/NI
If the LEDs fail at the end of their lives, they
 
must be repaired by a qualified electrician or
the entire product must be disposed of .
The power cord cannot be replaced; if the
 
power cord is damaged, the product shall be
disposed of .
Danger to life by
electric shock!
Always check the product for damage before
 
connecting it to the mains . Never use the
product if it shows any signs of damage .
Protect the power cord against sharp edges,
 
mechanical stresses and hot surfaces .
Always unplug the power cord from the socket
 
before installation, dismantling or cleaning .
Disconnect the product from the mains supply
 
if it is not going to be used for some time
(e .g . holiday) .
Prior to installation, verify that the mains
 
voltage on site corresponds with the operating
voltage required for the product (230 V∼,
50 Hz) . Otherwise do not install the product .
CAUTION! Risk of burn injuries! To
prevent burns, verify the product is switched off
and has cooled down for at least 15 minutes
before touching it . The product can become
very hot .
The accessible surface, especially heat shrink,
 
is very hot when the lamp is operating .
HG08006: The power plug
 
connected with a corresponding socket with
the same ingress protection (IP44) in order to
keep the protective degree against dust/water .
HG08006-BS: Power plug for indoor use only .
can only be
11 ]
[

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

387947 2104

Inhoudsopgave