Download Inhoudsopgave Inhoud Print deze pagina

Before Use; Charging The Product; Checking The Battery Capacity - Parkside PWLF 2200 A1 Bedienings- En Veiligheidsinstructies

Led-handlamp met powerbank
Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Risk of leakage of batteries /
rechargeable batteries
Avoid extreme environmental conditions and
 
temperatures, which could affect batteries /
rechargeable batteries, e.g. radiators / direct
sunlight.
If batteries / rechargeable batteries have
 
leaked, avoid contact with skin, eyes and
mucous membranes with the chemicals! Flush
immediately the affected areas with fresh water
and seek medical attention!
WEAR PROTECTIVE GLOVES!
Leaked or damaged batteries /
rechargeable batteries can cause burns
on contact with the skin. Wear suitable
protective gloves at all times if such an
event occurs.
This product has a built-in rechargeable battery
 
which cannot be replaced by the user. The
removal or replacement of the rechargeable
battery may only be carried out by the
manufacturer or his customer service or by
a similarly qualified person in order to avoid
hazards. When disposing of the product, it
should be noted that this product contains a
rechargeable battery.
˜ Before use
˜ Charging the product
NOTES:
Remove all packaging materials from the
 
product.
In order to use the product without a
 
USB cable
, you need to recharge the
[
]
rechargeable battery before use. The charging
process takes about 3 hours. The rechargeable
battery is firmly integrated into the base of the
product.
Fully charge the rechargeable battery prior to
 
first use.
Charge the battery if it becomes empty (only
 
1 LED of the charging indicator
Open the protective cap
 
Connect the USB plug of the USB cable
 
to the USB input socket (Type C)
product.
is flashing).
2 ]
[
.
5 ]
[
[
]
on the
6 ]
[
NOTES:
The battery charging status is shown by the
 
charging indicator
2 ]
[
Charging indicator
status
1 LED flashes
1 LED lights up, 1 LED flashes
2 LEDs light up, 1 LED flashes
3 LEDs light up
The charging time is approximately 3 hours
 
when the battery was drained.
NOTE: The product has an overcharging
protection system. Nevertheless, you should
disconnect the product from the mains once the
charging process is complete.
Disconnect the USB cable
 
to prevent the batteries discharging themselves.
Close the protective cap
 
use the product again. Otherwise water could
enter to the product when it is used outdoors.
The product is not working at temperatures
 
below 0 °C and above +45 °C due to its
battery protection.
˜ Checking the battery capacity
When product is not charged: Press the ON/OFF
switch
to check the battery capacity. The red
[
3 ]
charging indicator
shows the capacity* of the
2 ]
[
battery inside the product.
1 LED lights up = 33 %*
2 LEDs light up = 66 %*
3 LEDs light up = 100 %*
* This is the approximate percentage of battery
capacity but not actual measurement.
:
Battery
2 ]
[
charging status
0–33 %
34–65 %
66‒99 %
100 %
from the product
[
]
before you start to
5 ]
[
GB/IE/NI
9

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

392672 2201

Inhoudsopgave