Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
10
USE
10.1
ATTENTION
This appliance must not be used by people (childreen included) with reduced mobility,
psycological deseases or without experience and knowledge except in case of supervision
or instruction about the use of the appliance by people responsible for their safety.
Childreen must be constantly overseen in order to assure that they do not play with the
appliance.
The stove is provided with a hand rejector: this rejector can be removed exclusively by the
stove manufacturer or by the Technical Assistance Service.
During its running, the stove reaches high temperatures: keep away childreen and animals
and for your safety please use appropriate fireproof devices, such as heat-protecting gloves.
10.2
INTRODUCTION
To have the best performance with the lowest consumption please follow the here descripted instructions.
• The lightning of the pellets occurs very easily if the installation is correct and if the chimney flue is efficient.
• Switch on the stove at Power 1 for at least 2 hours in order to enable the materials which make up the boiler
and the fireplace to adjust the inner springing stress.
• Oily plant waste and lacquers can cause smells and smoke during the first working hours: it is advisable to
ventilate the room because they could be noxious to people and animals.
• By using the stove the varnish inside the combustion chamber could be subjected to alterations. This
occurrence can be attributed to different reasons: an excessive stove overheating, the presence of chemical
agents in bad quality pellets, bad chimney draught, etc. Therefore varnish endurance in the combustion
chamber cannot be guarantee.
Set values from 1 to 5 are defined by the manufacturer and they can be changed only by
an authorized technician.
Do not use flammable liquids during the ignition (alcool, petrol, oil, etc...).
10.3
CONTROL PANEL
PANEL ELEMENT
NICE - MIRIAM - CRISTAL - LEONORA - PRETTY - DIANA - KRISS - MARY
DESCRIPTION
P1 and P2: when in set temperature mode, they are useful to increase or decrease the
thermostat value from min. 6°C to max 40°C. Keeping pressed P2 key it is possible to
see the fume temperature at the exhaust. Both have programming functions.
EN
17
Advertenties
Hoofdstukken
Inhoudsopgave
