Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Carry out a practice run to determine the correct speed . In the tables below, you find
o
recommended values which help you to determine which belt and speed to use for which job:
Material and type of
works to be processed
Softwood
Hardwood
Chipboard
Removing paint/varnish
Rubbing down paintwork/varnish
Removing rust from steel
Plastics
Nonferrous metals
(e .g . aluminium)
˜ Stationary work
1 . Turn the additional handle
horizontal position .
2 . Turn over the product (Fig . E) and place it
on a stable worktop .
3 . Fit 2 screw clamps
provided . Clamp the product tightly .
˜ Cleaning and maintenance
m
WARNING!
Switch off the product and
disconnect it from the power before
replacing attachments, cleaning and
when not in use .
NOTE
Do not use chemical, alkaline, abrasive
u
or other aggressive detergents or
disinfectants to clean this product as they
might be harmful to its surfaces .
Let the product cool down before
u
cleaning .
14 GB/IE/NI
Recommended speed and abrasive belt
selection
Rough sanding
(grain size)
60
60
60
60
150
40
120
80
to the
[
2 ]
in the recesses
14 ]
[
8 ]
[
Finishing
(grain size)
240
180
150
–
320
120
240
150
NOTE
Regular and proper cleaning will help
u
ensure safe use and prolong the life of
the product .
Clean the product directly after finishing
u
work .
The product is maintenancefree .
u
Cleaning the product
Clean the product with a dry cloth .
o
Emptying/cleaning the dust collector
NOTE
Ensure ventilation openings are always
u
free .
Remove any adhering sanding dust with
u
a brush .
1 . Pull the dust collector
(see „Fitting/removing dust collector") .
2 . Empty the dust collector
knocking out the contents and then push
the dust collector back onto the product .
Speed
preselection
high (5–6)
high (5–6)
high (5–6)
high (5–6)
low (1–2)
medium/high (3–4)
low/medium (2–3)
medium/high (3–4)
off the product
11 ]
[
completely by
11 ]
[
Advertenties
Hoofdstukken
Inhoudsopgave
