Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
˜ Changing the saw blade
m
WARNING! RISK OF INJURY!
Always remove the power plug from
the mains power socket before carrying
out any work on the product.
Actuate the spindle lock
key
to loosen the tensioning screw
[
]
(turn clockwise to open). Remove the
tensioning screw
[
flange
(see also Fig. B).
[
]
Set the cutting depth to the maximum position.
Activate the safety lock-out
in that position. Swivel the base plate
upwards.
Remove the saw blade
Fit the saw blade in the reverse order as
described above.
Press the spindle lock button
engages) and use the hex key
the tensioning screw
The arrow on the saw blade must
correspond to the arrow showing the direction
of rotation
(running direction shown on
the product).
24 GB/IE/NI
and use the hex
[
]
[
]
and the clamping
]
and keep it
2 ]
[
[
7 ]
.
[
]
(until it
[
]
to tighten
[
]
.
[
]
˜ Switching the laser on and off
Switching on
Press the Laser on/off switch
Switching off
Press the Laser on/off switch
NOTE
If the battery is depleted, replace it with a
u
new 3 V button cell (type CR2032).
Have the carbon brushes replaced by the
u
manufacturer, its customer service or a
similarly qualified person.
Always keep the area around the protective
hood clean. Remove dust and shavings with a
brush or compressed air.
WARNING!
m
Always ensure that the power plug and
u
power cord are replaced only by the
manufacturer of the product or its customer
service. This will ensure that the safety of
the product is maintained.
.
[
]
again.
[
]
Advertenties
Hoofdstukken
Inhoudsopgave
