Fault Messages And Signal Tones; Warning Type Fault Messages - Dometic 10 Series Gebruiksaanwijzing
Verberg thumbnails
Zie ook voor 10 Series:
- Montagehandleiding (440 pagina's) ,
- Gebruiksaanwijzing (120 pagina's) ,
- Montagehandleiding en gebruiksaanwijzing (96 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
RMDT10
Fault
The refrigerator is not ade-
quately cooling.
7.1
Fault messages and signal tones
All faults are indicated with a warning symbol, a fault ID and a beep. The beeping
lasts for 2 minutes and is repeated every 30 minutes until the error has been rectified.
If multiple faults occur, the display shows the last fault. The underlying faults are dis-
played after the last fault has been confirmed.
Faults are indicated by a fault code with a warning symbol (
TFT display.
WARNING type fault messages
All faults of the WARNING type are reset automatically once the fault has been recti-
fied.
Code
Fault
W01
Defective temperature sensor in the
refrigerator compartment
W05
AC power not connected or
AC voltage < 190 V
W06
DC power not connected
W11
DC overvoltage (> 16 V).
EN
Possible cause
The ventilation around the cool-
ing unit is not sufficient.
The evaporator is iced up.
The temperature is set too high.
The ambient temperature is too
high.
Too much food was placed in the
refrigerator at once.
Too much warm food at once
was placed in the refrigerator.
The refrigerator has not been
operating for very long.
Suggested remedy
Check that the ventilation grill is not
obstructed.
Check whether the refrigerator door
closes properly. Make sure that the
refrigerator seal fits correctly and is not
damaged. Defrost the refrigerator.
Set a lower temperature.
Remove the ventilation grill for a while
so that warm air can escape quicker.
Remove an item of food.
Remove the warm food and leave it to
cool down before putting it in again.
Check the temperature again after four
or five hours.
) in the middle of the
Solution
Contact an authorized customer service.
Connect the refrigerator to AC or select a dif-
ferent energy type, e.g. gas or DC.
Connect the refrigerator to DC or select a dif-
ferent energy type, e.g. gas or AC.
Reduce the DC supply voltage.
Troubleshooting
33
Advertenties
Hoofdstukken
Inhoudsopgave
