Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Safety devices
Temperature limiter: This heater is fitted with a temperature limiter that switches the
heater off if the internal temperature rises to an unsafe level. If this safety device is
triggered, it may mean that your heater needs to be serviced.
If the temperature has dropped to under the reset-temperature, the heater can be used
again.
Electrical system safeguard: The heater's electrical system is protected by a safety fuse.
The fuse safeguards the electrical components against damage. If the heater does not
work, first check the fuse and replace it with a similar fuse if necessary.
Flame control: The heater uses a photoelectric cell to keep an eye on the combustion
chamber when the heater is operating. It will switch the heater off if the flame goes out.
Aftercooling: This heater is manufactured including an aftercooling system: the fan
continues to operate for some time after the heater has been switched off. The
aftercooling starts to operate when:
- The thermostat has stopped the heater.
- The overheating safeguard has stopped the heater.
- The heater has been turned off using a switch.
Aftercooling extends the lifespan of the heater. Therefore, do not remove the plug from
the socket immediately after switching off, but only after the fan has stopped.
Instructions for use
Read all instructions and warnings on the warning stickers and in the instruction booklet
and check the heater for defects!
Fueling:
Place the heater outdoors on a stable, flat and horizontal surface.
Remove the tank cap.
Fill the tank with clean paraffin or diesel till the fuel gauge points "F".
Replace the cap on the tank.
Note: Never replenish fuel if the heater is on or is still hot. Always wait until the heater has
cooled down before topping up the fuel.
Never fill up the fuel in an enclosed area; always do it outdoors.
Do not overfill the heater and remove any spilt fuel immediately and carefully, before
using the heater.
39
Advertenties
Inhoudsopgave
