Inhoudsopgave
Advertenties
Kennisgevingen
Handelsmerken
Lexmark en Lexmark met het diamantlogo zijn gedeponeerde handelsmerken van Lexmark International,
Inc. in de Verenigde Staten en/of andere landen.
Andere handelsmerken zijn eigendom van hun respectieve houders.
Conventies
Opmerking: hiermee wordt aangegeven dat een bepaald gedeelte nuttige informatie bevat.
Let op: hiermee wordt aangegeven dat een handeling kan leiden tot lichamelijk letsel.
Waarschuwing: hiermee wordt aangegeven dat een handeling kan leiden tot schade aan de hardware
of software van het product.
Copyrightinformatie
Het is mogelijk wettelijk niet toegestaan bepaald materiaal zonder toestemming of licentie te kopiëren,
waaronder zaken als documenten, afbeeldingen en geld. Als u niet zeker weet of het maken van een
bepaalde kopie is toegestaan, kunt u het beste juridisch advies inwinnen.
Electronic emission notices
Federal Communications Commission (FCC) compliance information
statement
TM
The Lexmark
8300 Series, type 4419, has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
The FCC Class B limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult your point of purchase or service representative for additional suggestions.
The manufacturer is not responsible for radio or television interference caused by using other than
recommended cables or by unauthorized changes or modifications to this equipment. Unauthorized
changes or modifications could void the user's authority to operate this equipment.
128
Advertenties
Inhoudsopgave
Probleemoplossen
