Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTALLATION/CONNECTION
Part list for installation
(A) Faceplate (×1)
(B) Trim plate (×1)
(C) Mounting sleeve (×1)
(D) Wiring harness (×1)
(E) Extraction key (×2)
Basic procedure
1 Remove the key from the ignition switch, then disconnect
the
terminal of the car battery.
2 Connect the wires properly.
See "Wiring connection" on page 19.
3 Install the unit to your car.
See "Installing the unit (in-dash mounting)".
4 Connect the
terminal of the car battery.
5 Detach the faceplate and reset the unit. (Page 3 or 4)
18
ENGLISH
Installing the unit (in-dash mounting)
Orientate the trim
plate as illustrated
before fitting.
Installing without the mounting sleeve
1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with screws
(commercially available).
Use only the specified screws. Using wrong screws might damage
the unit.
Hook on the top side
Bend the appropriate tabs to hold the
sleeve firmly in place.
Removing the unit
Do the required wiring.
(Page 19)
Dashboard of
your car
Advertenties
Hoofdstukken
Inhoudsopgave
