Inhoudsopgave
Advertenties
est position (position «7»);
– p ut the accelerator control between the
«SLOW» and «FAST» positions.
Mechanical transmission
Push the pedal down as far as possible (see
4.11) and move the gear change lever into
1st gear (see 4.12).
Keep the pedal pressed down and disen-
gage the parking brake. Slowly release
the pedal which will turn from «brake» to
«clutch», thus operating the rear wheels (see
4.11).
WARNING!
The pedal has to be re-
leased gradually, as a sudden engage-
ment may cause the vehicle to tip over
and the driver to lose control.
Gradually reach the desired speed using
the throttle and gear lever. To change gear,
press the clutch halfway down (see 4.11).
Hydrostatic transmission:
Disengage the parking brake and release
the brake pedal (see 4.21).
Press the drive pedal (see 4.22) in direction
«F» and reach the required speed by pro-
gressively increasing pressure on the pedal
and moving the accelerator.
WARNING!
Drive must be engaged
as described below (see 4.22) to prevent
sudden engagement from causing tipping
up and loss of control of the vehicle, par-
ticularly on slopes.
5.4.3 Braking
Mechanical transmission
To use the brake, press the brake pedal to
the floor (see 4.11), after reducing speed us-
ing the accelerator so as not to overload the
braking system.
Hydrostatic transmission
First reduce the machine's speed by reduc-
ing the engine's r.p.m., and then press the
brake pedal (see 4.21) to slow down the ma-
chine until it stops.
The machine already slows down consider-
ably by just releasing the drive pedal.
All manuals and user guides at all-guides.com
when the machine has stopped.
the cutting means engaged, it is necessary to
press and hold the consent pedal down (see 4.7)
so as not to cause the engine to stop.
To start cutting:
– move the throttle to «FAST»;
– b ring the cutting-means assembly to the high-
– e ngage the cutting means (see 4.3) only on
– s tart moving forwards on the grass very
– regulate the cutting height and speed (see
11
5.4.4 Reverse
IMPORTANT Reverse must only be engaged
IMPORTANT To proceed in reverse gear with
mechanical transmission
Press the pedal until the machine stops and
then switch into reverse by shifting the lever
sideways and into position «R» (see 4.12).
Gradually release the pedal to engage the
clutch and then begin moving in reverse.
Hydrostatic transmission:
When the machine is stopped, start the re-
verse movement by pressing the drive pedal
in the «R» direction (see 4.22).
5.4.5 Grass cutting
est position;
grass lawns; avoid engaging them on stony
ground or when the grass is very high;
slowly and with utmost caution, as already
described;
4.4) considering the conditions of the lawn
(the height, density and dampness of the
grass).
Mechanical transmission
– H igh and dense grass – wet lawn:
1st gear
– L ow grass – dry lawn: 2nd 3rd gear
NOTE The fourth gear is just a transfer
gear to be used on the flat.
Hydrostatic transmission
Speed can be adjusted according to lawn
conditions by gradually and continuously
pressingthe speed adjustment pedal ac-
cordingly.
Advertenties
Hoofdstukken
Inhoudsopgave
