Inhoudsopgave
Advertenties
including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radioexempts de licence. L'exploitation est
autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.
KC
B 급 기기: 이 기기는 가정용(B 급) 전자파적합기기로써
주로 가정에서 사용하는 것을 목적으로 하며, 모든
지역에서 사용할 수 있습니다.
Safety Instructions
These instructions are intended to ensure that
user can use the product correctly to avoid danger
or property loss.
Laws and Regulations
The device should be used in compliance with
local laws, electrical safety regulations, and fire
prevention regulations.
Transportation
Keep the device in original or similar packaging
while transporting it.
Keep all wrappers after unpacking them for
future use. In case of any failure occurred, you
need to return the device to the factory with the
original wrapper.
Transportation without the original wrapper may
result in damage on the device and the company
shall not take any responsibilities.
Do not drop the product or subject it to physical
shock. Keep the device away from magnetic
interface.
Power Supply
The input voltage for the device should meet the
Limited Power Source (5 VDC, 2 A) according to
the IEC61010-1 standard. Please refer to
technical specifications for detailed information.
The battery charger is included in the package.
The input voltage for the supplied battery
charger should meet the Limited Power Source
(5 VDC, 2 A).
Make sure the plug is properly connected to the
power socket.
DO NOT connect multiple devices to one power
adapter, to avoid over-heating or fire hazards
caused by overload.
Use the power adapter provided by qualified
manufacturer. Refer to the product specification
for detailed power requirements. The using
environment of the adapter should be consistent
with that of the device.
Battery
Improper use or replacement of the battery may
result in explosion hazard. Replace with the
same or equivalent type only. The battery type is
18650 with the protection board, and the
battery size should be within 19 mm × 70 mm.
The rated voltage and capacity are 3.6 VDC/
3.35 Ah (12.06 Wh). Dispose of used batteries in
conformance with the instructions provided by
the battery manufacturer.
Do not charge other battery types with the
supplied charger. Confirm there is no flammable
material within 2 m of the charger during
charging.
For long-term storage of the battery, make sure
it is fully charged every half year to ensure the
battery quality. Otherwise, damage may occur.
DO NOT place the battery near heating or fire
source. Avoid direct sunlight.
DO NOT swallow the battery to avoid chemical
burns.
The battery can not be charged with external
power source directly.
The device can not be charged, please use the
supplied charger to charge the battery.
This equipment is not suitable for use in
locations where children are likely to be present.
CAUTION: Risk of explosion if the battery is
replaced by an incorrect type.
Improper replacement of the battery with an
incorrect type may defeat a safeguard (for
example, in the case of some lithium battery
types).
Do not dispose of the battery into fire or a hot
oven, or mechanically crush or cut the battery,
which may result in an explosion.
Do not leave the battery in an extremely high
temperature surrounding environment, which
may result in an explosion or the leakage of
flammable liquid or gas.
Do not subject the battery to extremely low air
pressure, which may result in an explosion or the
leakage of flammable liquid or gas.
Dispose of used batteries according to the
instructions.
Maintenance
If the product does not work properly, please
contact your dealer or the nearest service center.
We shall not assume any responsibility for
problems caused by unauthorized repair or
maintenance.
Wipe the device gently with a clean cloth and a
small quantity of ethanol, if necessary.
If the equipment is used in a manner not
specified by the manufacturer, the protection
provided by the device may be impaired.
Clean the lens with soft and dry cloth or wiping
paper to avoid scratching it.
Using Environment
Make sure the running environment meets the
requirement of the device. The operating
temperature shall be -30 °C to 55 °C (-22 °F to
131 °F), and the operating humidity shall be 95%
or less, no condensing.
DO NOT expose the device to extremely hot, cold,
dusty, corrosive, saline-alkali, or damp
environments.
Avoid equipment installation on vibratory
surface or places subject to shock (neglect may
cause equipment damage).
Do not aim the lens at the sun or any other
bright light.
Emergency
If smoke, odor, or noise arises from the device,
immediately turn off the power, unplug the
power cable, and contact the service center.
Laser
When any laser equipment is in
use, make sure that the device lens
is not exposed to the laser beam, or
it may burn out. The laser radiation
emitted from the device can cause
eye injuries, burning of skin or inflammable
substances. Before enabling the light supplement
function, make sure no human or inflammable
substances are in front of the laser lens. Do not
place the device where minors can fetch it.
Manufacture Address
Room 313, Unit B, Building 2, 399 Danfeng Road,
Xixing Subdistrict,Binjiang District, Hangzhou,
Zhejiang 310052, China
Hangzhou Microimage Software Co., Ltd.
COMPLIANCE NOTICE: The thermal series
products might be subject to export controls in
various countries or regions, including without
7
Advertenties
Inhoudsopgave
