Inhoudsopgave
Advertenties
Problem
The appliance does not drain the
water.
The anti-flood device is on.
After the checks are completed, turn the
programme knob until the programme
marker is aligned with programme that
was in operation when the problem oc-
curred. The programme continues from
the point of interruption.
If the problem occurs again, contact the
Service.
If other alarm codes show, contact the
Service.
9.1 If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
10. TECHNICAL INFORMATION
Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
1)
Cold water or hot water
Place settings
Left-on mode
Off-mode
Possible solution
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or
bends.
Close the water tap and contact the Service.
• The quantity of detergent is too much.
Stains and dry water drops on
glasses and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector
to a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature drying
phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
Refer to 'HINTS AND TIPS' for
other possible causes.
2)
ENGLISH
600 / 850 / 625
220 - 240 V
50 Hz
(0.5 / 0.05 ) / (8 / 0.8 )
max. 60 °C
0.50 W
0.50 W
71
12
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
