Inhoudsopgave
Advertenties
Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
Explanation of the symbols used (see Fig. 22)
1. Danger! - Read the operating instructions to
reduce the risk of injury.
2. Caution! Wear ear-muff s. The impact of noi-
se can cause damage to hearing.
3. Caution! Wear a breathing mask. Dust
which is injurious to health can be generated
when working on wood and other materials.
Never use the device to work on any materi-
als containing asbestos!
4. Caution! Wear safety goggles. Sparks ge-
nerated during working or splinters, chips and
dust emitted by the device can cause loss of
sight.
5. Overload switch
6. Caution! Risk of injury! Never reach into
the planing knife during operation.
7. Direction of rotation of the knife shaft.
8. Feed side of the workpiece. The feed side
is marked with an arrow for both surfacing /
thicknessing.
9. Conditions of the mains connection
10. Power rating
11. Speed
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
WARNING!
Read all safety warnings, instructions, illust-
rations and specifi cations provided with this
power tool. Failure to follow all instructions listed
below may result in electric shock, fi re and/or
serious injury.
Save all warnings and instructions for future
reference.
This machine is not intended to be used by per-
sons (including children) with reduced physical,
Anl_TC-SP_204-1_SPK13.indb 22
Anl_TC-SP_204-1_SPK13.indb 22
GB
sensory or mental capacities or those with a lack
of experience and/or knowledge. Children must
always be supervised in order to ensure that they
do not play with the tool.
2. Layout and items supplied
2.1 Layout (Fig. 1-21)
1. On/Off switch
2. Push block
3. Push stick
4. Hand crank
5. Chip extractor
6. Parallel stop
7. Clamping lever
8. Extraction adapter Ø 100 mm
9. Setting knob for the chip depth
10. Workpiece support
11. Rubber foot
12. Planing knife cover
13. Feed table
14. Planing table
15. Setting gauge for planing knives
16. Surfacing safety switch
17. Recess for surfacing safety switch
18. Surfacing depth scale
19. Surfacing depth pointer
20. Thicknessing table
21. Planing knife
22. Slotted bar
23. Knife shaft
24. Anti-kick claws
25. Spring in knife shaft
26. Planing knife tightening screws
27. Feed roller
28. Discharge roller
29. Thicknessing scale
30. Thicknessing pointer
31. Wing screw on chip extractor
32. Grub screw on chip extractor
33. Chip extractor washer
34. Chip extractor wing nut
35. Overload switch
36. Washer for rubber feet
37. Socket head screw for rubber feet
38. Parallel stop angle scale
39. Parallel stop pointer
40. 0° adjustment screw
41. 45° adjustment screw
42. Holder for parallel stop
43. Cover plate for knife
44. Parallel stop socket head screw
45. Swing arm
- 22 -
21.08.2024 08:30:21
21.08.2024 08:30:21
Advertenties
Inhoudsopgave
