Defrosting
en
Defrosting
=
R efrigerator compartment
D e f r o s t i n g
The defrost process is performed automatically.
Freezer compartment
The fully automatic NoFrost system ensures that
the freezer compartment remains free of ice. Defrosting
is no longer required.
Cleaning
D
C aution!
C l e a n i n g
Avoid damaging the appliance and the fittings.
–
Do not use abrasive, chloride or acidic cleaning
agents or solvents.
–
Do not use scouring or abrasive sponges.
The metallic surfaces may corrode.
–
Never clean the shelves or containers
in the dishwasher.
The parts may become deformed.
Proceed as follows:
1
Switch off the appliance.
2
Pull out the mains plug or switch off the fuse.
3
Take out the food and store in a cool location.
If present: place ice pack on the food.
4
If present: wait until the layer of frost has thawed.
5
Clean the appliance with a soft cloth, lukewarm
water and a little pH-neutral washing-up liquid.
Caution!
The rinsing water must not run into the light or
through the drainage hole into the evaporation area.
6
Wipe door seal with clear water and dry thoroughly
with a cloth.
7
Reconnect and switch on appliance and put in food.
42
Cleaning the equipment
To clean, take the variable parts out of the appliance.
"Interior fittings" on page 31
~
Partition and vegetable container cover
Taking out the partition
▯
Remove glass plate, press levers on the underside
on both sides, pull partition forwards, lift and swivel
out to the side.
1
Taking out the vegetable container cover
▯
Lift cover, pull forwards and swivel out to the side.
Inserting vegetable container cover and partition
1
Insert vegetable container cover.
2
Insert partition.
3
Insert glass plate.
Telescopic rails
Removing telescopic rails
1
Pull out telescopic rail.
2
Push lock in the direction of the arrow.
3
Detach telescopic rail from the rear pin.
4
Push telescopic rail together, push backwards
above the rear pin and disengage.
4
2
3