Advertenties
Care of the Liion batteries
• Never use a battery with clogged air vents. Clean the air vents carefully using a dry,
soft brush.
• Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery
to high levels of moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a
non-flammable container and consult Hilti Service.
• Keep the battery free of extraneous oil and grease. Do not permit dust or dirt to
accumulate unnecessarily on the battery. Clean the battery with a dry, soft brush or a
clean, dry cloth. Do not use cleaning agents containing silicone as these can attack
the plastic parts.
Do not touch the contacts of the battery and do not remove the factory-applied grease
from the contacts.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents
containing silicone as these can attack the plastic parts.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make
sure that they all function correctly.
• Do not use the product if signs of damage are found or if parts malfunction. Immediately
have the product repaired by Hilti Service.
• After cleaning and maintenance, install all guards and protective devices and check
that they are in full working order.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and
consumables. Spare parts, consumables and accessories approved by Hilti for use
with your product can be found at your Hilti Store or online at: www.hilti.group
7.1
Replacing bandsaw blade cover
Replace the bandsaw blade cover as soon as you find signs of damage.
1. Slacken the screws of the bandsaw blade cover.
2. Remove the damaged bandsaw blade cover and dispose of it correctly.
3. Position the new bandsaw blade cover on the bandsaw.
4. Tighten the screws of the bandsaw blade cover to 2 to 3 Nm.
7.2
Changing rubber ring
Replace the rubber ring as soon as you find signs of damage.
1. Remove the bandsaw blade → page 29.
2. Remove the rubber ring.
3. Check that the guide grooves are free of foreign matter and clean them if necessary.
4. Stretch the new rubber ring over the pulley for the bandsaw blade.
5. Ease the rubber ring into position on the pulley until it is fully flush with the guide
grooves.
6. Re-install the bandsaw blade. → page 29.
32
English
5
6
2354065
*2354065*
Advertenties
