Advertenties
ATTENTION
Damage to property due to wrong bandsaw blade. Using a wrong bandsaw blade can
lead to premature material fatigue and damage to the bandsaw.
▶ Select the correct bandsaw blade for the bandsaw and the material.
▶ Select the bandsaw bade with the correct tooth pitch (teeth per inch, tpi) for the
material you are going to cut: higher tpi for hard/thin materials; lower tpi for soft/thick
materials.
▶ Use only bandsaw blades that are 0.5 mm thick. Thicker bandsaw blades mean more
bending strain and accelerated wear of the saw teeth.
▶ Select the bandsaw blade such that at least two saw teeth are in contact with the
workpiece.
▶ Use only bandsaw blades with the dimensions 1140 mm × 12.5 mm × 0.5 mm.
Check the rubber ring for damage at regular intervals.
After every cutting operation, remove dust and chips from the bandsaw blade covers and
the cutting guide to prolong the useful life of the bandsaw.
To start the bandsaw, you must: First press the control switch and then press the
safety switch and hold both switches down at the same time.
The weight of the bandsaw is sufficient to make the cut. Do not apply additional
pressure to the bandsaw.
1. Replace the rubber ring when necessary. → page 32
2. Change the bandsaw blade when necessary. → page 29
3. Press and hold down the control switch.
4. Press and hold down the safety switch.
5. Position the bandsaw on the workpiece in such a way that as many saw teeth as
possible act on the workpiece.
6. Carry out the sawing work.
Guide the bandsaw in such a way that at least three saw teeth remain in the cut
at all times if possible.
7. Release the control switch.
7
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents
containing silicone as these can attack the plastic parts.
• Use a dry, clean cloth to clean the contacts of the product.
*2354065*
2354065
English
31
Advertenties
