Advertenties
3.3
Items supplied
Bandsaw, bandsaw blade, operating instructions
Other system products approved for use with this product can be found at your local
Hilti Store or at: www.hilti.group
3.4
Status indicators of the Liion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's
state of health.
3.4.1 Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶ If the release button is pressed with a battery inserted in the product, subsequently
check that the battery is correctly re-engaged and secure.
Short-press the release button of the battery to get whichever of the following status
indications is applicable at the time.
State of charge and, if applicable, faults are indicated constantly as long as the connected
product is switched on.
Status
Four (4) LEDs show constantly green
Three (3) LEDs show constantly green
Two (2) LEDs show constantly green
One (1) LED shows constantly green
One (1) LED slow-flashes green
One (1) LED quick-flashes green
One (1) LED quick-flashes yellow
One (1) LED shows yellow
One (1) LED quick-flashes red
26
English
Meaning
State of charge: 100 % to 71 %
State of charge: 70 % to 51 %
State of charge: 50 % to 26 %
State of charge: 25 % to 10 %
State of charge: < 10 %
The Li-ion battery is completely
discharged. Recharge the battery.
If the LED again starts quick-flashing after
the battery has been charged, consult
Hilti Service.
The Li-ion battery or the product in which
it is inserted is overloaded, too hot or too
cold, or experiencing some other fault.
Bring the product and the battery to the
recommended working temperature and
do not overload the product when it is in
use.
If the message persists, consult Hilti Ser-
vice.
The Li-ion battery and the product in
which it is inserted are not compatible.
Consult Hilti Service.
The Li-ion battery is locked and cannot be
used. Consult Hilti Service.
2354065
*2354065*
Advertenties
