REPLACE
A registered transmitter can be replaced with another transmitter without having access to the receiver.
Use the transmitter that will replace the old transmitter to perform the following instructions.
Do not perform this action when the receiver is in a session with another
transmitter. The radio communication may be interrupted or broken.
The replacement transmitter will control all receivers it has been registered
in, provided that no other transmitter is logged in.
IMPORTANT! Before replacing a damaged or missing transmitter with a new one,
check if the transmitter used as replacement is already registered in any other receiver.
If necessary, erase the transmitter from other receivers before performing the
replacement procedure.
1. Make sure that the stop button is pressed.
2. Press button 8. Keep pressed.
3. Twist and pull out the stop button.
4. Release button 8.
The top LED flashes (green).
5. WITHIN 1 MINUTE OF PULLING OUT THE STOP BUTTON:
Enter the code: 1–2–3–4 (press buttons 1, 2, 3, 4). LEDs 1–4 light up (red). If the code is invalid,
the transmitter switches off. When the code is accepted, the top LED flashes (green). LEDs 1–4
flash (red).
6. WITHIN 1 MINUTE OF ENTERING THE CODE:
Press button 3.
The top LED lights (green). LED 2 flashes (red).
7. Enter the Replace ID (a maximum of 11 digits) for the transmitter being replaced by pressing the
transmitter buttons.
LED 3 lights (red) when one or more digits have been entered.
LEDs 3 and 4 light (red) when the maximum number of digits (11) have been entered.
IMPORTANT! The Replace ID label is placed in the back of the
(000000)
Replace ID: 000000000
transmitter. Remove the rubber cover.
IMPORTANT! When entering the last digit in the code, keep that
button pressed until the stop button has been pressed.
8. Press the stop button. Release the last Replace ID button.
After approximately 10 seconds the transmitter switches off.
If the replace procedure fails, press the stop button and start again.
- 18 -