Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ABOUT THIS DOCUMENT
Every care has been taken in the preparation of this manual. Please inform Tele Radio AB of any
inaccuracies or omissions.
These installation instructions cover general safety issues, main technical specifications, standard
installation, configuration and operating instructions, general troubleshooting and battery information.
Images shown in this document are for illustrative purposes only.
Term and symbol definitions
The capitalized terms and symbol used herein shall have the following meaning:
WARNING! indicates a hazardous situation which, if not avoided, could result in death or
n
serious injury.
CAUTION! indicates a hazardous situation which, if not avoided, will result in minor or
n
moderate injury.
IMPORTANT! is used for information that requires special consideration.
n
NOTE! is used to address practices not related to physical injury.
n
This symbol is used to call attention to safety messages that would be assigned the signal words
"WARNING" or "CAUTION".
WARNINGS & RESTRICTIONS
Carefully read through the following safety instructions before proceeding
with the installation, configuration, operation or maintenance of the product.
Failure to follow these warnings could result in serious injury and property
damage.
Installing, connecting and mounting
This radio system must not be used in areas where there is a risk of explosion.
n
Tele Radio AB remote controls are often built into wider applications. Those systems
n
should be equipped with:
a wired emergency stop where necessary.
n
a brake.
n
an audible or visual warning signal.
n
Always switch off all electrical power from the equipment before installation procedure.
n
Only licensed or qualified personnel should be permitted to install the product.
n
To utilize the safety of the system, use the stop relays in the safety circuitry of the object
n
that you want to control.
When the equipment controlled by the receiver's standard relays is connected via the
n
stop relays, make sure that the maximum current through the stop relays is still within
the specifications. Contact your representative for assistance.
Avoid registering transmitters in receivers where they are not being used.
n
- 4 -
Advertenties
Hoofdstukken
Inhoudsopgave
