Advertenties
Beschikbare talen
Beschikbare talen
5. Close the fuel tank by fitting the cap and then turning it clockwise.
6. Close the fuel canister.
5.2
Assembly and adjustment
WARNING
Risk of injury. Contact with the rotating cut-off wheel can lead to injury. Hot parts of the machine or a hot
cut-off wheel may cause burning injuries.
▶ Before fitting or adjusting any parts of the product, make sure that the engine is switched off, that the
cut-off wheel has completely stopped rotating and that the product has cooled down.
▶ Wear protective gloves.
5.2.1
Fitting a cut-off wheel
WARNING
Risk of injury and damage. Unsuitable cut-off wheels or unsuitable parts used to secure the wheel can suffer
irreparable damage during operation or lead to loss of control of the product or breakage of the accessory tool.
▶ Make sure that the cut-off wheel's maximum permissible speed is at least as high as the maximum
spindle speed stated on the product. Use only cut-off wheels, flanges and screws that are suitable for
your product.
▶ Use only cut-off wheels with a mounting hole diameter of 20 mm or 25.4 mm (1") and that are a correct
fit on the centering bushing.
WARNING
Risk of injury and damage. Damaged cut-off wheels may break.
▶ If the cut-off wheel has been subjected to an impact, check the cut-off wheel for damage and replace it
if necessary.
▶ Never use cut-off wheels that are damaged, run untrue or vibrate.
▶ Don't use synthetic resin-bonded fiber-reinforced cut-off wheels which have exceeded their use-by date
or already softened due to water absorption.
WARNING
Risk of injury and damage. Over-tightening securing screws can lead to damage or breakage of the
securing screw itself or the washer fitted to the securing screw.
▶ Be sure to tighten the securing screw to the specified tightening torque.
▶ Take care not to overtighten the securing screw.
WARNING
Risk of injury! Incorrect installation or removal of the cut-off wheel can result in loose parts getting into the
eyes and causing injuries.
▶ Always wear eye protection (protective goggles) when changing the accessory tool.
1. Insert the locking pin in the hole in the drive belt cover and turn the cut-off wheel until the locking pin
engages.
2. Release the securing screw by turning the screw counterclockwise with the wrench and then remove the
screw and washer.
3. Remove the locking pin.
4. Remove the clamping flange and the cut-off wheel.
5. Check that the diameter of the arbor hole in the cut-off wheel to be installed matches the centering collar
of the cut-off wheel centering bushing.
The centering bushing has a 20 mm diameter centering collar on one side and a 25.4 mm (1")
diameter centering collar on the other side.
6. Clean the clamping and centering surfaces on the product and on the cut-off wheel.
7. Place the cut-off wheel with centering collar on the drive arbor and check that the direction of rotation is
correct.
▶ The direction-of-rotation arrow on the cut-off wheel must match the direction of rotation indicated on
the product.
8. Place the clamping flange and washer on the drive arbor and tighten the securing screw by turning it
clockwise.
*2271384*
3
2271384
English
31
Advertenties
