Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4. Storage
Store you treadmill in a clean and dry environment. Ensure the master powers witch is off and is un-plugged
from the electrical wall outlet.
5. Belt adjustment
All running belts are properly set at the factory and after assembly. However, slack may occur after a period
of use. Such as : pause and slip may occur when running. When this phenomenon occurs, adjust the
running belt and screw in half a turn left and right. If the running belt is loose, the running belt and the roller
will slip in turn. But too tight is also not good, which is easy to increase the load of the motor and damage
the motor, running belt and roller, etc.
Adjusting the belt deviation
All running belts are properly set at the factory and after assembly. But after a period, the belt have the possibility
for deviation. The reasons can be listed as follows.
4. The treadmill is unstable.
5. Feet didn't in the central of the running belt when running.
6. Feet exert uneven force.
If deviation caused by manual, No - load rotation for a few minutes can return to normal. Adjusting step by
step in half a turn with a 6mm Allen wrench that is equipped randomly for unable to restore automatically.
Such as left deviation of running belt.
Adjust the left screw clockwise or the right screw anti-
clockwise.
KEY POINT:
- Clockwise means tighten.
-Anti-clockwise means loosen.
-Running belt will shift to the loose side.
①If the running belt shifts to the left, that means the left side is too loose. Adjust the left bolt clockwise to
make the left tighter.Or adjust the right screw anti-clockwise to make the right looser.
②If the running belt shifts to the right, that means the right side is too loose. Adjust the right bolt clockwise
to make the right tighter Or adjust the left screw anti-clockwise to make the left looser.
Attention:
-You need to start the treadmill (let the belt run) at a low speed before you adjust the running belt.
-When you adjust the bolt, don't rotate it too much.
-After each adjustment you need to look for the changes in the running belt. Running belt deviation is not
covered by the warranty, and is mainly maintained by users according to the instructions. Running
Such as right deviation of running belt.
Adjust the right screw clockwise or the left screw anti-
clockwise.
27
Advertenties
Inhoudsopgave
