Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Supplementary notes
GB
■
Secure the workpiece. A workpiece securely
IE
held by a clamping device or vice is much safer
than one held in your hand.
■
Hold the power tool firmly. High reaction
moments can occur for brief periods while
tightening and loosening screws.
■
Switch the power off immediately if the tool
blocks while in use. Be prepared for high reac-
tion moments as these can cause kickback.
■
While working on the appliance, transporting
it or storing it, always set the rotation direc-
tion switch to the centre position (lock).
This prevents the power tool from starting up
unintentionally.
■
CAUTION, POWER CABLES! DANGER!
Ensure that you are not likely to contact power,
gas or water supply lines when you are working
with the power tool. If necessary, check with
a service line detector before you start to cut
or drill into a surface.
6
All manuals and user guides at all-guides.com
Before use
Charging the battery pack (see fig. A)
►
■
♦
♦
♦
♦
♦
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
♦
Removing the battery pack:
♦
Checking the battery charge level
♦
♦
CAUTION!
Always unplug the appliance before you
remove the battery pack from or connect
the battery pack to the charger.
Never charge the battery pack when the
ambient temperature is below 10°C or above
40°C.
Connect the battery pack
charger
(see Fig. A).
Insert the power plug into the socket. The control
LED
will light up red and indicates the charg-
ing process.
The green control LED
charging process is complete and the battery
pack
is ready.
Insert the battery pack
ance.
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Move the rotation direction switch
middle position (lock). Allow the battery pack
to click into the handle.
Press the release button
battery pack.
Press the ON/OFF switch
of the battery (see also main diagram).
The status/remaining charge will be shown on
the battery display LED
GREEN/RED/ORANGE = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery
to the rapid battery
indicates that the
back into the appli-
to the
and remove the
to check the status
as follows:
PABS 16 A1
Advertenties
Hoofdstukken
Inhoudsopgave
