Advertenties
Beschikbare talen
Beschikbare talen
EN
If the appliance operates abnormally aer storage
and checks don't isolate the problem, the injector
may be blocked. A blocked injector is indicated by
a weaker yellowish flame or no flame at all. In such
cases, remove and thoroughly clean the injector to
remove any foreign matter.
Remove the injector using standard tools and blow
out any dirt. Alternatively, purchase new injectors
from your local store. Do not attempt mechanical
cleaning of the injector.
Replacing a blocked injector
Your appliance is fitted with a specific size injector to
regulate the correct amount of gas. If the injector hole
is blocked, it may cause a weak flame, or no flame at all.
Avoid cleaning the injector with a pin or similar device
as it may damage the injector, posing a safety risk to the
appliance. To replace the injector, do the following:
Fig.
on page 6
1. Remove the fat pan.
2. Remove the three screws on the heat shield plate
and remove the heat shield.
3. Remove the two screws on the burner assembly and
remove it, taking care to not damage the connected
igniter wire.
4. Use a suitable spanner to remove the injector; avoid
using pliers as this may damage the injector. Screw
the new injector into the valve, being careful not to
over-tighten to avoid damage.
12 Spares
Fig.
on page 7
NOTE Always use genuine spares. Contact
your local supplier for help.
13 Warranty
The statutory warranty period applies. If the
product is defective, please contact your retailer
or the manufacturer's branch in your country. (see
www.cadacinternational.com/support)
For repair and warranty processing, please include the
following documents when you send in the product:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
14
Note that self-repair or non-professional repair can have
safety consequences and might void the warranty.
Advertenties
