Advertenties
Beschikbare talen
Beschikbare talen
EN
4 Gas leaks
Gas leaks from damaged hoses or improper
connections can create hazardous conditions and
must be addressed immediately. It is vital that all gas
connections have been correctly fitted to prevent gas
leaks.
DANGER! Explosion hazard
If you smell gas, immediately turn the gas
off at the gas cylinder valve as well as on
the appliance by turning the control knob
clockwise to "OFF" position.
Extinguish any naked flames
Move the appliance to a flame-free
location and perform a gas leak test. This
test should be performed outside in a well-
ventilated area away from open flames or
sources of ignition.
Never use a naked flame to check for gas
leak, use soapy water.
How to carry out a gas leak test
A gas leak test must be done every time a hose and
regulator is fitted to the appliance and gas supply, and
every time the gas supply is changed.
DANGER! Failure to identify and control
a gas leak may result in potential injury
or death.
To carry out a gas leak test, apply soapy
water to all connection points along the
gas hose, i.e. to the connection between
gas hose and appliance, and to the
connection between the regulator and gas
supply.
Slowly open the gas cylinder valve to allow
gas flow.
If bubbles form on any conection point,
then there is a gas leak.
Immediately turn the gas off and
disconnect the gas supply from the
appliance. Confirm that all gaskets are in
place and in good condition. Replace any
gaskets that show signs of damage.
Reconnect the gas supply to the appliance
and reperform the gas leak test.
Should the gas leak persist, return the
product to your authorized repair agent for
assistance.
10
Flame stability
Ensure flame stability when using the appliance.
WARNING! Uncontrolled light-back
(flame burning back inside the burner or
nozzle housing) may lead to dangerous
operating conditions.
In the event of light-back, immediately
turn off the gas supply by closing the
gas cylinder valve first, then turning the
appliance control knob to "OFF." Aer
the flame is extinguished, remove the
regulator and check the gasket condition;
replace it if necessary.
Reconnect the gas supply and re-light the
appliance.
Should the flame persistently light-back,
return the product to your authorized
repair agent for assessment.
5 Component List
Fig.
on page 3
①
Component
②
Domed lid / Pot
③
Barbecue griddle
④
Flat griddle
⑤
Pan support
⑥
Drip pan
⑦
Burner
⑧
Control knob
⑨
Igniter
⑩
Quick release connection
⑪
Flat lid
⑫
BBQ 2 Plancha 30
Paella Pan 30
Model Components
Model combinations for the range are as follows:
6545-10
1
X
2
X
3
X
Description
6545-20
6545-25
X
X
X
X
X
Advertenties
