Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problem
The appliance does not drain the water.
The anti-flood device is on.
After the checks are completed, activate
the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the
Service.
If other alarm codes appear, contact the
Service.
If the washing and drying results are
not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector to
a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying phase
or with a low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tablets
can be the cause. Try a different brand or
TECHNICAL INFORMATION
Dimensions
Electrical connection
All manuals and user guides at all-guides.com
Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap and contact the Service.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Possible solution
activate the rinse aid dispenser and use
rinse aid together with the combi deter-
gent tablets.
Refer to 'HINTS AND TIPS' for other
possible causes.
Activating the rinse aid dispenser with
the multitab option activated
1. Press the on/off button to activate the
appliance. The on/off indicator comes
on. Make sure that the appliance is in
setting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
2. Press and hold function buttons (B) and
(C) at the same time until the indicators
of function buttons (A), (B) and (C) flash.
3. Press function button (B).
• The indicators of function buttons (A)
and (C) go off.
• The indicator of function button (B)
continues to flash.
• The end indicator is off.
4. Press function button (B) to change the
setting.
• The end indicator comes on. The
rinse aid dispenser is active.
5. Deactivate the appliance to confirm.
6. Adjust the released quantity of rinse aid.
7. Fill the rinse aid dispenser.
progress 25
596 / 818 - 878 / 575
220-240 V
50 Hz
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
