Download Inhoudsopgave Inhoud Print deze pagina

Technical Information - Progress PVX1535 Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

24 progress
Problem
The appliance does not drain the water.
The anti-flood device is on.
After the checks are completed, activate
the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the
Service.
If other alarm codes appear, contact the
Service.
If the washing and drying results are
not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector to
a higher position.

TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
1)
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot water
supply to decrease energy consumption.
All manuals and user guides at all-guides.com
Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap and contact the Service.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Cold water or hot water
Place settings
Left-on mode
Off-mode
Possible solution
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying phase
or with a low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
Refer to 'HINTS AND TIPS' for other
possible causes.
2)
596 / 818 - 898 / 550
220-240 V
50 Hz
(0.5 / 0.05 ) / (8 / 0.8 )
max. 60 °C
12
1.90 W
0.10 W

Advertenties

Inhoudsopgave
loading

Inhoudsopgave