Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
23. OPERATION AND FUNCTIONING OF THE CHARGING STATION
23.1 Operation:
Take the plug from the holder of the charging station that is suited to your
vehicle.
Then insert it in your vehicle. If both CHAdeMO and CCS charging points are
available, only one can be used at a time.
Initiate the start/stop procedure by holding your charging card up to the
scanning point.
Firstly the plug is locked onto the vehicle.
The charging station then communicates with the vehicle and the back-
office system. Once all security and payment guidelines have been checked,
the maximum permissible charging current is forwarded. After some time, it
can occur that the charging station activates the cooling systems fitted for
this purpose to dissipate the excess heat via the venting duct.
The charging procedure is now activated automatically and the DC charging
process can be followed on the screen. The AC charging process is indicated
by a small light.
To stop the charging process, hold your pass up to the scanning point. The
charging process then stops. You can now remove the plug and hang it back
up in the available holder.
23.2 Emergency stop
In case of emergency, the emergency stop button must always be used.
When activating the emergency stop button, the charging process is
disconnected directly, both in terms of software and hardware.
After careful inspection, the back-office system concerned will reset
the emergency setting. The emergency stop button will also have to be
deactivated on site for this purpose.
24. TECHNICAL SPECIFICATIONS
AC INPUT
Input voltage:
Input frequency:
Power factor:
24
The charging station is operated using a charging card.
The charging card must be registered in the relevant back-
office system. This required registration can also be done
during office hours by calling Ecotap® B.V. Tel. +31 (0)411 745
020. Once registration is complete, the charging station can be
used with any Electric Transport charging card (EV charging
card) or other suitable cards, both mobile and key holder.
3 x 400VAC + N ± 10%
50Hz
Rated output load PF ≥ 0.99
Advertenties
Hoofdstukken
Inhoudsopgave
