Advertenties
Beschikbare talen
Beschikbare talen
DE
The bag is not being
EN
welded correctly
FR
IT
ES
NL
The bag does not hold
PT
the vacuum after it has
been welded shut
SE
The sealing bar seals
even before the end
of the vacuum sealing
process.
PLEASE NOTE
If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
9
Disposal of the Old Device
Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety. If these were put in the non-recyclable waste or
were handled incorrectly, they could be detrimental to human health and the
environment. Therefore, do not put your old device into the non-recyclable
waste under any circumstances.
PLEASE NOTE
Please take your old unit to the nearest recycling center for safe disposal.
Until it can be disposed of properly, store your old unit away from children.
38
CASO VRH 790 advanced Pro
The welding bar is overheating
so that the bag melts
The bag is defective
There are leaks along the
welding seam as a result of
creases, crumbs, grease or
liquids
The weld seam is not sealed all
the way through.
The food inside the bag has
formed gases.
The sealing bar has become
too hot due to too many
passes in quick succession
and is sealing the bags even
though not all the air has been
extracted
Open the cover on the unit and
let it cool down for a few minutes
Select another bag; wrap paper
serviettes around any sharp
edges on the content
Open the bag again and clean
the upper internal part of the
bag and remove any foreign
matter that might be on the
welding bar before you weld the
bag shut again
Cut off the seal and start the va-
cuum and sealing process again.
Blanch vegetables such as
cabbage and broccoli before
vacuum sealing them
Open the cover on the unit and
let it cool down for a few minutes
Advertenties
